|
Post by harmonist34 on Feb 17, 2023 20:58:40 GMT -5
I've got a single choke tube that's labeled MOD-LEAD FULL-STEEL, so I think that would perform as a full choke with the steel HEVI-shot loads, right?
From what I can tell, Browning doesn't recommend an extra full with steel shot as it may be too tight. So is the choke I have about as good as I'm going to find for steel shot?
|
|
|
Post by (Not Ronald) Reagan on Feb 17, 2023 22:07:30 GMT -5
A full should be as good as you need. Is the Citori rated for 3” shells or 2 3/4”?
|
|
|
Post by harmonist34 on Feb 18, 2023 7:01:31 GMT -5
It’s labeled on the barrel “2 3/4 - 3 AND 3 1/2” so I should have plenty of options. Assume those options are valid for either barrel?
|
|
|
Post by drfleck on Feb 18, 2023 9:08:44 GMT -5
I'm sure those will work just fine. As long as the pattern is acceptable. I'm shooting long beards 3inch #5 through a cheap Truglo turkey choke. I've only killed a couple of turkeys with this set up and both were inside twenty yards where the pattern is almost too tight. Out at forty yards I'm still getting a nice, full pattern.
|
|
|
Post by titanium700 on Feb 18, 2023 20:07:25 GMT -5
Longbeards have in my and my sons guns at least the tightest most consistent patterns. The 3” #5’s are my tightest patterns and better than the 3 1/2” ers.
|
|