|
|
Post by Woody Williams on Aug 5, 2005 15:38:59 GMT -5
|
|
|
|
Post by jh45gun on Aug 5, 2005 22:49:05 GMT -5
Would 22 be long enough if you have 20 inch bolts? I know my bolts are 16 inches or a shade over and I cannot put them in 18 inch box with broadheads on them. Too bad too as it was a nice aluminum case. ? Jim
|
|
|
|
Post by John on Aug 6, 2005 6:55:45 GMT -5
jh45gun:
These box's leave very little room on ends with broadheads installed. But they work.
I did'nt appreciate the room so I went to the 24" in. size and deeper box as seen in the "What you got posts", this way I can easily fit 36 bolts if neccessary. And still have 1-1/2 in. all around and ends with broadheads. But these are a good cheap little box .
john
|
|
|
|
Post by Woody Williams on Aug 6, 2005 8:09:53 GMT -5
jh45gun: These box's leave very little room on ends with broadheads installed. But they work. I did'nt appreciate the room so I went to the 24" in. size and deeper box as seen in the "What you got posts", this way I can easily fit 36 bolts if neccessary. And still have 1-1/2 in. all around and ends with broadheads. But these are a good cheap little box . john John, Where did you get the 24" box from? |
|
|
|
Post by John on Aug 6, 2005 8:23:35 GMT -5
Hey Woody:
I believe I said before it was a Stanley box, however I was wrong , it is a "Plano" 24 in. box with yellow hold down clamps and one shelf inside which I disposed of. It is approx. 8 in. deep. And I found it at Wal- Mart. As well I bought the high density foam from there to. It is a very strong ,secure box that can be locked as well.
Hope this helps.
john
|
|
|
|
Post by Woody Williams on Aug 6, 2005 9:07:42 GMT -5
Hey Woody: I believe I said before it was a Stanley box, however I was wrong , it is a "Plano" 24 in. box with yellow hold down clamps and one shelf inside which I disposed of. It is approx. 8 in. deep. And I found it at Wal- Mart. As well I bought the high density foam from there to. It is a very strong ,secure box that can be locked as well. Hope this helps. john WalMart?? I should have known they seem to have everything , don't they? I'll check them out and compare them to the Sears box. Thanks.. |
|
|
|
Post by digger on Aug 6, 2005 12:07:14 GMT -5
Job Mate at Canada Tire ($15 bucks Can.) these are 23x7x4 in and I have lots of room for 20" carbons and slick trick broad heads. John you must have giant broadheads if you lack space. Digger    |
|
|
|
Post by John on Aug 6, 2005 13:28:30 GMT -5
Hey Digger:
Crossbolt = 21-1/2 in. with broadhead on, I believe when I measured at Canadian Tire the box you show there was 22 in. inside measurement. And the height with the handle indentation dropped from 4 outside to 3 in. inside. Just a little to close with everything crammed in. So for $4.00 more I went with the Plano lots of space and tolerance, nothing crammed in or even close to each other as in your picture. To each his own I always say.
They both work for cheap price.
john
|
|
