|
Post by HighCotton on Dec 21, 2020 10:01:09 GMT -5
I didn't really think this fit in the Firearms section so I'm posting it here. I recently acquired a nice Glock 43 with a good assortment of magazines, holsters, upgrades and grip options. Much thanks to bullseye69 for his help, BTW!!! One of the grip options that came with the gun was the Hogue Beavertail Grip Sleeve. The noted item #2 in the instructions states: "Hogue emphasizes grip security and safety over ease of installation. Depending on your model of firearm, the installation may be a strenuous process to ensure a perfect fit." Man! They got that right! I felt that if I pulled and stretched any more that I would rip the grip sleeve in half!!! Based on their further instructions and notes I found on other handgun forums, I tried various options from boiling water to Windex to soap and water, etc. Those combinations did not work for me. One other suggestion worked like a charm. I used Hand Sanitizer combined with a sleeve soaked in near-boiling water for a few minutes. I coated the gun grip and the inside of the sleeve with the sanitizer. A few old timers on a forum assured that the sanitizer would have no ill effects on the grip or the sleeve once installed and left to dry overnight! I figured I'd risk it. It literally took less than 2 minutes to install:
|
|
|
Post by featherduster on Dec 21, 2020 10:07:32 GMT -5
Is there any moisture under the grip that could rust the metal?
|
|
|
Post by dbd870 on Dec 21, 2020 10:30:59 GMT -5
Been a while since I owned one. Not sure there is any metal in that area
|
|
|
Post by HighCotton on Dec 21, 2020 10:40:31 GMT -5
Is there any moisture under the grip that could rust the metal? From what I've read and understand, the grip is all polymer on the Glock. If not, someone feel free to correct me. Also, the main ingredients in the sanitizer are various alcohols, glycerin and glycol which dissipate any moisture and then evaporate. I know the glycerin helps with some of the lubrication. I use glycerin on a regular basis when servicing industrial ultrapure water systems. I should've probably noted that I completely dried the sleeve before completely coating the inside with the sanitizer.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 21, 2020 11:19:15 GMT -5
Heating it up to expand it is the only thing I can think of. Of course need to know the material heat tolerance. Hopefully up to couple hundred degrees, then try sliding on. Could also cool the Clock in the refrigerator to contract.
|
|
|
Post by bartiks on Dec 21, 2020 13:05:27 GMT -5
Nice to know, if I ever think of doing that to mine I'll definitely reference this little bit of knowledge.
|
|
|
Post by Woody Williams on Dec 21, 2020 14:15:34 GMT -5
Love the Hogue grips. Got one on my LCP but I’ll be danged if I remember how I installed. I think it was just stretch and pull. Lot smaller grip so that could make a difference. .
|
|
|
Post by esshup on Dec 21, 2020 15:42:45 GMT -5
Is there any moisture under the grip that could rust the metal? Good One!!!
|
|
|
Post by omegahunter on Dec 22, 2020 10:25:38 GMT -5
The sleeve I had for my Bodyguard .380 ripped trying to stretch it getting started on the grip. Hogue sent a replacment.
|
|